Salta al contenuto principale

iMac Intel 27" Retina 5K Display 2020 Klebestreifen am Display ersetzen

Inglese
Tedesco

Traduzione in corso passo 12

Passo 12
iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement: passo 0, immagine 1 di 3 iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement: passo 0, immagine 2 di 3 iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement: passo 0, immagine 3 di 3
  • Place adhesive strip 25 on your work surface with the white side facing up and the opening of the microphone notch facing away from you.

  • Measuring from the center of the microphone notch, make two marks on the adhesive strip as guides for where to cut:

  • Make the first mark 13/16 inch (23 mm) right of the notch

  • Make the second mark 1 & 5/16 inch (29 mm) right of the notch

  • Rotate the adhesive strip so that the notch is now facing toward you.

  • Measuring from the bottom edge of the strip, make a third mark in between the first two 5/32 inch (4 mm) up from the bottom edge.

  • This cut will be very close to the top edge of the adhesive strip, but it's important that you leave material over top of the adhesive strip for proper sound isolation. When in doubt, remove less material than you think you need to. If the adhesive still covers the microphone you can always make the notch bigger.

Lege Streifen 25 mit der weißen Seite nach oben auf deine Arbeitsfläche, so dass die Aussparung für das Mikrofon von dir weg zeigt.

Markiere zwei Stellen Stellen für einen späteren Schnitt. Miss dazu von der Mitte der Aussparung aus:

Die erste Marke ist 23 mm rechts von der Mitte der Aussparung aus.

Die zweite Marke ist 29 mm rechts von der Mitte der Aussparung aus.

Drehe den Klebestreifen herum, so dass die Aussparung zu dir hin zeigt.

Zeichne nun eine weitere Linie zwischen den beiden anderen 4 mm von der Unterkante entfernt.

Diese Linie liegt sehr nahe an der Oberkante des Klebestreifens, es ist aber wirklich wichtig, dass ein schmaler Streifen übrig bleibt, um den Schall gut zu isolieren. Lasse im Zweifelsfall lieber etwas mehr vom Material stehen. Wenn der Klebestreifen später das Mikrofon überdeckt, kannst du immer noch nachschneiden.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.