Salta al contenuto principale

Sostituzione adesivo schermo iMac Intel 27" Display Retina 5K 2020

Inglese
Italiano

Traduzione in corso passo 2

Passo 2
iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement, Remove the old adhesive: passo 0, immagine 1 di 2 iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement, Remove the old adhesive: passo 0, immagine 2 di 2
Remove the old adhesive
  • Before you install new adhesive strips, remove all of the old adhesive from the perimeter of the rear enclosure.

  • If you are re-using your existing display, you must also remove the old adhesive from the back of the display.

  • Peel off the adhesive strips using tweezers or your fingers. Start at the bottom and peel upward towards the top of the device.

  • After all the old adhesive is removed, carefully clean the surface with 90% (or greater) isopropyl alcohol and a lint-free cloth. Wipe in one direction, not back and forth.

  • Don't skip this step, or your new adhesive strips may not bond properly, and the display may fall out of your iMac.

Prima di installare nuove strisce adesive, rimuovi tutto il vecchio adesivo dal perimetro del case posteriore.

Se stai riusando il display, devi anche rimuovere il vecchio adesivo dal retro dello schermo.

Rimuovi le strisce adesive usando delle pinzette o le dita. Comincia dal fondo e rimuovile verso l'alto verso la parte superiore del dispositivo.

Dopo aver rimosso tutto il vecchio adesivo, pulisci attentamente la superficie con alcool isopropilico al 90% (o superiore) e un panno senza lanugine. Passalo in una sola direzione e non avanti e indietro.

Non saltare questo passo, o le nuove strisce adesive potrebbero non fare bene presa e lo schermo potrebbe cadere dall'iMac.

[title] Remove the old adhesive
[* icon_note] Before you install new adhesive strips, remove all of the old adhesive from the perimeter of the rear enclosure.
[* black] If you are re-using your existing display, you must also remove the old adhesive from the back of the display.
- [* black] Peel off the adhesive strips using tweezers or your fingers. Start at the bottom and peel ''upward'' towards the top of the device.
+ [* black] Peel off the adhesive strips using [product|IF145-020|tweezers] or your fingers. Start at the bottom and peel ''upward'' towards the top of the device.
[* black] After all the old adhesive is removed, carefully clean the surface with 90% (or greater) isopropyl alcohol and a lint-free cloth. Wipe in one direction, not back and forth.
[* icon_caution] ***Don't skip this step***, or your new adhesive strips may not bond properly, and the display may fall out of your iMac.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.