Salta al contenuto principale

Sostituzione adesivo schermo iMac Intel 27" Display Retina 5K 2020

Inglese
Italiano

Traduzione in corso passo 16

Passo 16
iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement: passo 0, immagine 1 di 3 iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement: passo 0, immagine 2 di 3 iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement: passo 0, immagine 3 di 3
  • The microphone hole is the center hole flanked by two larger holes.

  • Align the adhesive strip to the bottom edge by positioning the microphone notch over the microphone hole.

  • If your iMac does not have a microphone hole, align the right end of the strip such that the L-bend sits next to the right vertical adhesive. The L-bend should not overlap the right vertical adhesive.

  • The adhesive tears easily. Be careful not to pull on the strip with too much force.

  • Once you have aligned the strip, carefully set the left exposed edge onto the iMac to secure the alignment.

Il foro del microfono è il foro centrale circondato da due fori più grandi.

Allinea la striscia adesiva al bordo inferiore posizionando l'incavo del microfono sul foro del microfono.

Se il tuo iMac non ha un foro del microfono, allinea l'estremità destra della striscia così che la curva a L si trovi accanto all'adesivo verticale destro. La curva a L non deve sovrapporsi all'adesivo verticale destro.

L'adesivo si strappa facilmente. Fa' attenzione a non tirare sulla striscia con troppa forza.

Una volta che hai allineato la striscia, posiziona attentamente il bordo sinistro esposto sull'iMac per fissare l'allineamento.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.