Rep: 53
1
5
The problem started with a shreded belt. That was replaced. Then the check printhead path error showed up. The rods have been oiled, the carriage height has been adjusted. When it powers up it runs through some self tests then the carriage moves a fraction of an inch and the error pops up.
Questa è una buona domanda?
Rep: 25
2
Either the belt pulley is broken, or installed incorrectly, or the belt was installed backwards.
Questa risposta è stata utile?
Ultime 24 Ore: 0
Ultimi 7 Giorni: 0
Ultimi 30 Giorni: 0
Tutti i Tempi: 229
