Aggiusta la tua roba Comunità Store

Wahl Chrome Pro Power Cord Replacement

Introduzione

The power cord connects the clipper to a power supply. If the power cord wiring breaks due to repeated bending, the power cord may need replacement. Replacing a broken power cord makes sure the clippers receive the power needed to run the device.

Cosa ti serve

  1. Wahl Chrome Pro Power Cord Replacement, Case: passo 1, immagine 1 di 1

    • Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.

    • Make sure your device is not connected to power before you begin.

    Traduci

  2. Wahl Chrome Pro Power Cord Replacement: passo 2, immagine 1 di 1

    • Lift the bottom blade straight up from the device body to remove it.

    Traduci

  3. Wahl Chrome Pro Power Cord Replacement: passo 3, immagine 1 di 1

    • Remove the three 9.0 mm JIS #1 screws attaching the base of the blade assembly to the body.

    Traduci

  4. Wahl Chrome Pro Power Cord Replacement: passo 4, immagine 1 di 1

    • Lift the base of blade assembly straight up off of the body.

    Traduci

  6. Wahl Chrome Pro Power Cord Replacement: passo 5, immagine 1 di 1

    • Remove the two 12.0 mm JIS #1 screws on the back of the device body.

    Traduci

  7. Wahl Chrome Pro Power Cord Replacement: passo 6, immagine 1 di 1

    • Remove the 13.0 mm Phillips #2 screw on the side of the device body.

    • This screw is located on the opposite side of the body from the switch.

    Traduci

  8. Wahl Chrome Pro Power Cord Replacement: passo 7, immagine 1 di 1

    • Remove the spring on the side of the body using tweezers.

    Traduci

  9. Wahl Chrome Pro Power Cord Replacement: passo 8, immagine 1 di 1

    • Pry the body case off of the device using a spudger.

    Traduci

  10. Wahl Chrome Pro Power Cord Replacement, Power Cord: passo 9, immagine 1 di 2 Wahl Chrome Pro Power Cord Replacement, Power Cord: passo 9, immagine 2 di 2

    • Remove one 7.5 mm JIS #1 screw from the switch base.

    Traduci

  11. Wahl Chrome Pro Power Cord Replacement: passo 10, immagine 1 di 1

    • Unplug the cord terminal from the motor connector.

    Traduci

  12. Wahl Chrome Pro Power Cord Replacement: passo 11, immagine 1 di 1

    • Remove the cord from the device base by pulling gently.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 4 altri collaboratori

Manuel Salazar M.

Membro da: 11/07/17

101 Reputazione

1 Guida realizzata

Distintivi: 3

Team

IUPUI, Team S7-G3, Baechle Fall 2017 Membro di IUPUI, Team S7-G3, Baechle Fall 2017

IUPUI-BAECHLE-F17S7G3

3 Membri

4 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 6

Tutti i Tempi: 764