Traduzione in corso passo 2
Passo 2
Fan assembly
-
The fan and air guidance assembly is attached to the main PCB with 2 screws.
-
Each fan has one connector for power and one for the pod sensor - these need to be disconnected from the PCB before removing the fan assembly. If you want to replace a fan, you will need to unhook the sensor cables from the sides.
-
Fans used are: 1604KL-01W-B39-B00 NMB Technologies DC Fans DC Axial Fan, 40x10mm, 5VDC, 4.2CFM
I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.