Salta al contenuto principale

Introduzione

The LCD should be checked if the screen is blank or broken.

  1. Open the battery compartment and remove the batteries.
    • Open the battery compartment and remove the batteries.

    • Remove all of the visible screws on the outside of the case.

    • There should be three of them that are all easily located.

  2. Open the memory card compartment.
    • Open the memory card compartment.

    • Remove the screw next to the memory card slot.

  3. Pull apart the front and back cover pieces carefully.
    • Pull apart the front and back cover pieces carefully.

    • The front cover should come completely free with little effort.

    • The back cover will still be attached to the circuit board.

  4. Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.
    • Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.

    • The circuitry will still be connected to the back case by ribbon cables.

  5. Open the case as shown.
    • Open the case as shown.

  6. Unclip the clip holding the ribbon cable in.
    • Unclip the clip holding the ribbon cable in.

    • Other ribbon cables might not have a clips.

  7. Pull the ribbon cable out.
    • Pull the ribbon cable out.

  8. Unclip the ribbon cable shown the in picture.
    • Unclip the ribbon cable shown the in picture.

    • Some ribbon cables do not have a clip holding them in.

  9. Pull the ribbon cable out.
    • Pull the ribbon cable out.

  10. Remove 7 Screws to remove plate and expose LCD screen.
    • Remove 7 Screws to remove plate and expose LCD screen.

  11. Remove LCD plate to expose LCD components and ribbon cables
    • Remove LCD plate to expose LCD components and ribbon cables

  12. Check connection of LCD to cables
    • Check connection of LCD to cables

    • If cables are intact, disconnect cables and replace LCD with new part

  13. Repeat steps in reverse order to reassemble the camera
    • Repeat steps in reverse order to reassemble the camera

Conclusione

To reassemble your device, follow these instructions in reverse order.

Mark

Membro da: 11/01/2011

13 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 3-43, Regan Winter 2011 Membro di Cal Poly, Team 3-43, Regan Winter 2011

CPSU-REGAN-W11S3G43

4 Membri

10 Guide realizzate

I don’t know the cause of my camera not turning on.

Smgmc64 Productions - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 2,295