Logitech Harmony Smart Keyboard Back Panel

Ultimo aggiornamento il November 11, 2022

10 - 15 minuti

Facile

Introduzione

This is a prerequisite guide that will instruct you on how to properly open your keyboard. This will be helpful for replacing internal components without damaging your device.

Cosa ti serve

Strumenti

Mostra di più…

Passo 1 Back Panel

Logitech Harmony Smart Keyboard Back Panel, Back Panel: passo 1, immagine 1 di 2

Logitech Harmony Smart Keyboard Back Panel, Back Panel: passo 1, immagine 2 di 2

Turn keyboard over to the backside.

Traduci

Passo 2

Logitech Harmony Smart Keyboard Back Panel: passo 2, immagine 3 di 3

Press and slide up on the upper battery latch, using both thumbs.

Traduci

Passo 3

Remove the two AA batteries and set them aside.

Traduci

Passo 4

Unscrew all five 4.0 mm screws, using Phillips #1 screwdriver.

Traduci

Passo 5

Peel off the center sticker to reveal two hidden 4.0 mm screws.
Unscrew these two screws with a Phillips #1 screwdriver.

Traduci

Passo 6

Logitech Harmony Smart Keyboard Back Panel: passo 6, immagine 3 di 3

Lift both top left and top right rubber stickers halfway, using the sharp end of the plastic spudger.
Unscrew a total of two 4.0 mm screws, under the rubber stickers, using a Phillips #1 screwdriver.

Traduci

Passo 7

Unscrew the top center 4.0 mm screw, in the battery compartment, using the Phillips #1 screwdriver.
Now, you should have a total of ten 4.0 mm screws set aside.

Traduci

Passo 8

Logitech Harmony Smart Keyboard Back Panel: passo 8, immagine 3 di 3

Wedge the flat end of the spudger between the back panel and front panel.
Slide the flat end of the spudger from right to left to pry the two panels apart.

Traduci

Passo 9

Logitech Harmony Smart Keyboard Back Panel: passo 9, immagine 3 di 3

Separate the back panel from the front panel completely, using both hands.
A white ribbon flex cable will remain connected to both panels.
Pull the panels apart slowly and gently, or the white ribbon flex cable may be unsafely removed.