HP Stream 7 Screen Replacement

Ultimo aggiornamento il 9 ott 2018

7 minuti

Facile

Introduzione

Since HP Stream 7 is a tablet and has many small parts. Be careful when removing/replacing parts. Do not force anything to avoid breaking device material.

Cosa ti serve

Strumenti

Mostra di più…

Passo 1 Battery

HP Stream 7 Screen Replacement, Battery: passo 1, immagine 1 di 2

HP Stream 7 Screen Replacement, Battery: passo 1, immagine 2 di 2

Make sure the tablet is powered off before beginning.
Gently run the plastic opening tool or your fingernails around the tablet to pry the Back Cover from the tablet.

Modifica

Passo 2

Remove the eight 5 mm Phillips 000 screws.
Gently run the plastic opening tool around the seam to pry the mid back cover from the tablet.

Modifica

Passo 3

Attrezzo utilizzato in questo passaggio:

Tweezers

$4.99

Using tweezers, gently pull the battery connector towards the battery to remove it from the System Board.
Pull the blue tabs (Not Shown) out from the tablet at an angle to remove the tape underneath the Battery.
If you broke both tabs, scrape the tape and Battery off.
Scraping off the Battery will damage it. If you are replacing another part, leave the Battery on the display panel.

Modifica

Bonjour,

j'ai suivi la procédure pour remplacer la batterie, sans problème.

Cependant, la nouvelle batterie ne se recharge pas. J'ai changé de câble et de chargeur au cas où le problème viendrait de là mais sans succès. De plus, quand je branche la tablette sur le chargeur, elle indique bien être connectée au secteur mais sans charge de la batterie.

Quand je consulte le Bios, je vois que le numéro de série de batterie affiché est celui de l'ancienne batterie.

Y aurait-il une action à entreprendre à ce niveau ?

En vous remerciant par avance pour l'aide que vous pourriez m'apporter

Philippe

Jacquemin Philippe - 19 mag 2024 Replica

Passo 4 Motherboard Replacement

HP Stream 7 Screen Replacement, Motherboard Replacement: passo 4, immagine 1 di 1

Disconnect the battery from the motherboard, but leave the battery on the display panel (unless you have already taken it off).
Disconnect the motherboard from the rear-facing camera, the front-facing camera, the antenna, the power button board, the screen, and the display panel using your spudger.
The cable connected to the display is adhered to the panel, so be careful when removing the cable (like most things here).
If you are inexperienced with disconnecting everything, "Recognizing and Disconnecting Cable Connectors" is a helpful ifixit guide.