Introduzione
Need to take apart your mug press? Button got pressed too hard and now is askew in the machine? This is the guide for you.
-
-
Place your device to be taken apart on a clean flat surface with plenty of space.
-
-
-
Remove two plastic screw covers from bottom using a pick tool.
-
remove two screws using driver.
-
-
-
-
Remove the two rubber screw covers and stick them about one inch above the screws.
-
Remove two screws and place aside.
-
Press the lever flush and remove upper plastic.
-
-
-
Remove six screws and place aside
-
Lift lever and gently remove lower plastic for lever.
-
-
-
Metal lever bracket needs to be in the up position.
-
Gently remove the housing careful to not damage the attached power and usb cables
-
-
-
Switch is held in place with two screws.
-
If the screws break lose you can replace them with HDD screws
-
Gently thread two HDD screws until tension holds the board in place and no further.
-
DO NOT OVER-TIGHTEN SCREWS.
-
Perform steps in reverse to reassemble being careful to place cables behind the heat shield.
-
3 Commenti
Is the screw a 32*5/8th. Everywhere I look I can’t find that size there is more to the sizing. Any help would greatly appreciated. Thanks so much for this post.
They are #6 HDD screws. You can find them on Amazon. Under Hard Drive screws.
Hola! Mi maquina titila el 3r led. He pasado muchas veces actualización y nada. Que podría ser? Podrías ayudarme?
