Salta al contenuto principale

更换三星盖乐世S6的后部玻璃面板

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Cinese

Traduzione in corso passo 1

Passo 1
Samsung Galaxy S6 Rear Glass Replacement: passo 0, immagine 1 di 2 Samsung Galaxy S6 Rear Glass Replacement: passo 0, immagine 2 di 2
  • Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.

  • If your glass is shattered, put packing tape over the entire panel to hold it together during the removal process.

  • Lay the heated iOpener over the rear panel for about two minutes to loosen the adhesive around the edge of the glass.

  • You may need to reheat and reapply the iOpener several times to get the phone warm enough. Follow the iOpener instructions to avoid overheating.

  • Shift the iOpener to heat the remaining section of the panel for another two minutes.

  • A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the OLED display and internal battery are both susceptible to heat damage.

拆开后盖后手机防水会失效。 在拆机前, 请准备好替换用的胶带或是胶水。 如果不准备更换后壳自带的胶水, 请避免后壳沾到任何液体。

如果手机的玻璃面板已经碎裂,请在拆卸过程中用胶带固定住整个面板。

将iOpener放置在手机后盖上2分钟左右,以软化后盖的上的胶水。

你可能需要使用 iOpener 多次以达到足够的温度。 请按照 iOpener 的说明操作以避免过度加热。

移动iOpener以加热后壳的剩余部分,同样大约需要两分钟

吹风机,热风枪,或者加热工具也许都会用到,但是千万不要过度加热手机——OLED 屏幕和内部电池都会容易热损坏。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.