Traduzione in corso passo 1
Passo 1
-
Use the T5 Torx Screwdriver to remove the twelve screws on the bottom of the laptop. Once the screws are removed, lift off the bottom panel.
-
Use the Phillips #0 Screwdriver to remove the twelve screws holding the heatsink in place.
-
Carefully pull the two black tabs on either side of the black ribbon to disconnect them from the board.
-
Gently pull off the inner black ribbon to remove it from the board.
-
Use the Phillips #0 Screwdriver to remove the two screws holding the mSATA.
-
With a gently tug, disconnect the four white plugs.
-
Use the Phillips #0 Screwdriver to remove the two screws holding the wireless card.
I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.