Il mio banco da lavoro

Ottieni un rapido accesso alle guide, ai componenti e alle risposte per i tuoi dispositivi

Ionic Breeze LED Replacement

Torna alla Guida

Inglese

Italiano

Passo precedente Passo successivo

Traduzione in corso passo 2

Passo 2

Ionic Breeze LED Replacement, Desolder/Resolder LEDs: passo 0, immagine 1 di 2

Ionic Breeze LED Replacement, Desolder/Resolder LEDs: passo 0, immagine 2 di 2

Desolder/Resolder LEDs

When desoldering and removing the OEM LEDs, make sure to leave one soldered in place to use as a height reference.
I replaced the "Low" LED first. It's the only one on the PCB that doesn't have a surface mount capacitor.
When removing the "High" and "Medium" LEDs be careful not to loose the capacitor. These are highlighted in red. It is possible to do this without removing it from the PCB as shown in Photo 2. Just reapply solder if needed.
Repeat until all 3, or the desired number, of LEDs are replaced.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.