Traduzione in corso passo 18
Passo 18
Release the belt tension
-
Use a Phillips screwdriver to remove the 18.5 mm‑long tensioning screw from the bracket towards the back of the left side of the Cricut
-
Screw the nut away from the head of the screw by a few full turns.
-
Screw the screw into the hole in the bracket until the nut makes contact with the bracket.
-
Use a 6 mm wrench to hold the nut and screw in the screw until the belt reaches the correct tension.
I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.