Salta al contenuto principale

Modifiche al passo #8

Modifica in base a Adam O'Camb-

Modifica approvata da Adam O'Camb

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Slide the blade of a halberd spudger into the opening on the edge of the rear button bracket.
[* icon_noteicon_caution] Careful not to push directly against the rear button ribbon cable, to avoid damaging it.
[* icon_caution] Do not push the spudger in too far, to avoid damaging the rear button.
[* icon_noteicon_caution] Careful not to push directly against the rear button ribbon cable, to avoid damaging it.
[* icon_caution] Do not push the spudger in too far, to avoid damaging the rear button.
[* black] Continue sliding the spudger blade around the base of the bracket to cut all the adhesive holding the bracket to the rear case.
[* black] Remove the bracket.