Modifiche al passo #1
Modifica di Christina Walden —
Modifica approvata da Christina Walden
- Prima di
- Dopo il
- Invariato
Righe Passo
| [* black] Remove all the marked screws using a PH00 screwdriver. | |
| [* red] Remove the two 3mm screws on the grip. | |
| [* orange] Remove the two 4mm screws on the side opposite the grip. | |
| [* yellow] Remove the three 4mm screws on the base of the camera. | |
| [* green] Remove the four 3mm screws on the base of the camera. | |
| - | [* icon_note] Make sure not to pull too hard because there are connector ribbons. |
| - | [* icon_note] Detach the connector ribbons before fully separating the camera into two pieces. This is outlined in the next step. |