Modifiche al passo #6
Modifica di Giovanni Román —
Modifica approvata da Giovanni Román
- Prima di
- Dopo il
- Invariato
Righe Passo
| - | [* black] This last step is for cubes |
|---|---|
| + | [* black] This last step is for cubes with this feature, like some older speed cubes. |
| [* black] Remove the cap to expose the screw attached to the core. | |
| - | [* black] Tighten the screw on any sides that might seem loose to prevent any future poppings. |
| + | [* black] ***Note *** You can remove the cap with your nails or any prying tool like a wooden popsicle stick. |
| + | [* black] Tighten the screws that are loose as much as you would like to prevent any future pops. ( It can be anywhere from 180° to 360°) |
| + | [* black] ***Note*** You can use any generic Phillips head screwdriver to tighten it. |