Modifiche al passo #6
Modifica di Aaron Collard —
Modifica approvata da Aaron Collard
- Prima di
- Dopo il
- Invariato
Righe Passo
| - | [* black] Position the device so that the top panel is flat. You should have access to the USB Port. |
|---|---|
| - | [* black] |
| + | [* black] Position the device so that the top panel is flat down on the table. You should have access to the USB Port. |
| + | [* black] Desolder the 2 joint and 4 wires in the back of the USB port. |
| [* black] Remove the the component from the board. | |
| [* icon_caution] Excessive heat can damage the port, so do not apply the soldering iron to the component for too long. |