Modifiche al passo #1
Modifica di Debra Crawford —
Modifica approvata da Debra Crawford
- Prima di
- Dopo il
- Invariato
Righe Passo
| [* black] Place the drone on its back, with the runners facing upward. | |
| [* black] Using the Phillips screwdriver, unscrew the single 2mm screw located on the drone body which connects the headlamp and wiring to the center of the drone frame. | |
| [* black] Grasp one of the propeller arms with the fingers of one hand while holding the drone frame with the other hand. . | |
| [* black] Next, pull the propeller arm upward to separate it from the drone body. Repeat this process to remove the three other propeller arms. | |
| [* black] Carefully remove the drone body from the frame. | |
| - | [* black] |
| + | [* black] Flip the body onto the runners so the wires are facing upward. |