Pericolo
Potenzialmente Pericoloso
Possibilità di infortunio se questa procedura non viene seguita correttamente. Prestare attenzione e seguire tutte le avvertenze.
Pericolo

Introduzione

When your brakes get worn down, they need to be replaced. This will help keep you safe as you ride.

Parti

Nessuna parte richiesta.

  1. Note: In this repair guide the pictures are taken with the tire removed so that it is easier to follow our steps. However, removing the tire is not necessary to replace the brake pads. Unscrew the brake pad cap with a T25 screwdriver bit.
    • Note: In this repair guide the pictures are taken with the tire removed so that it is easier to follow our steps. However, removing the tire is not necessary to replace the brake pads.

    • Unscrew the brake pad cap with a T25 screwdriver bit.

  2. Grab and pull out the spring between the brake pads. Grab and pull out the spring between the brake pads. Grab and pull out the spring between the brake pads.
    • Grab and pull out the spring between the brake pads.

  3. Slide out the back brake pad first. Then slide out the front brake pad. Slide out the back brake pad first. Then slide out the front brake pad. Slide out the back brake pad first. Then slide out the front brake pad.
    • Slide out the back brake pad first. Then slide out the front brake pad.

  4. Spedizione gratuita per tutti gli ordini superiori a 100,00 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  5. Slide in the new brake pads with the first going in the front. Slide in the new brake pads with the first going in the front.
    • Slide in the new brake pads with the first going in the front.

  6. Then slide in the other pad in the back. Make sure each brake pad is facing the right way. Make sure each brake pad is facing the right way.
    • Then slide in the other pad in the back.

    • Make sure each brake pad is facing the right way.

  7. Push the spring back into place between the two brake pads so the spring is visible in the hole shown here. Push the spring back into place between the two brake pads so the spring is visible in the hole shown here. Push the spring back into place between the two brake pads so the spring is visible in the hole shown here.
    • Push the spring back into place between the two brake pads so the spring is visible in the hole shown here.

  8. Screw the brake pad cap back on. Screw the brake pad cap back on.
    • Screw the brake pad cap back on.

  9. Adjust the red knob as necessary (directions are noted on the knob).
    • Adjust the red knob as necessary (directions are noted on the knob).

Conclusione

Now your bike should actually be able to stop.

Ben Hartinger

Membro da: 27/01/2014

340 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 1-37, Maness Winter 2014 Membro di Cal Poly, Team 1-37, Maness Winter 2014

CPSU-MANESS-W14S1G37

4 Membri

6 Guide realizzate

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 280