Logitech Harmony Companion Button Pad Replacement

Ultimo aggiornamento il December 13, 2017

2 minuti

Facile

Introduzione

The buttons on your Companion remote may stop working or become damaged. This guide will show you how to replace the button pad in your remote. All you'll need for this guide is a plastic opening tool and Phillips #0 screwdriver.

Cosa ti serve

Strumenti

Mostra di più…

Passo 1 Remote Battery

Logitech Harmony Companion Button Pad Replacement, Remote Battery: passo 1, immagine 1 di 1

Hold the remote with the Logitech label toward you.

Modifica

Passo 2

Push the battery cover upward.

Modifica

MY Logitech Harmony smart control does NOT have a battery door. There is absolutely no way to get to any battery HELP

ussscamp - 22 lug 2020 Replica

Passo 3

Logitech Harmony Companion Button Pad Replacement: passo 3, immagine 3 di 3

Use your finger to lift the battery out of the compartment.
When the battery has lifted, push it up to remove it.

Modifica

Passo 4 Remote Motherboard

Logitech Harmony Companion Button Pad Replacement, Remote Motherboard: passo 4, immagine 1 di 2

Logitech Harmony Companion Button Pad Replacement, Remote Motherboard: passo 4, immagine 2 di 2

Remove the two 5.0 mm Phillips #0 screws.

Modifica

Passo 5

Use the plastic opening tool to pry open the back cover of the remote.
It is recommended to have the point of the opening tool facing the back of the remote.
Insert the opening tool on each side of the bottom of the remote, and pull up until you hear the cover click open.
Pry the back cover off by sliding the plastic opening tool down each side.

Modifica

Passo 6

Use the plastic opening tool to remove the motherboard.

Modifica

Pay careful attention to how the battery holders (the wires at the top) are positioned before removing, especially the springs which are designed to push the battery out when lifted, but if not carefully reinstalled will not allow the battery click into place.

Tom Scott - 5 mag 2020 Replica