Canon PowerShot SX230 HS LCD Screen Replacement
Introduzione
Vai al passo 1Having trouble with your LCD screen? Use this guide to replace the camera's screen. No background information is necessary.
Cosa ti serve
Strumenti
-
-
Remove the two 2.5 mm screws located on the right side of the camera using the Phillips #000 Screwdriver
-
Unscrew the two 2.5 mm screws located on the side of the camera. Then, remove the two black 2.5 mm screw located on the bottom of the camera.
-
-
-
-
Using your fingers, carefully remove the ribbon cable located at the top right of the camera. Then pull off the camera's front casing.
-
-
-
Remove the two 2.5 mm screws that secures the camera buttons to the camera located on the right side of the camera. Then, remove the screw located on the side of the screen. Now, locate the screw under the LCD screen and remove it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Altre 6 persone hanno completato questa guida.
Team
Sam Houston State, Team 13-20, Blackburne Spring 2015 Membro di Sam Houston State, Team 13-20, Blackburne Spring 2015
SHSU-BLACKBURNE-S15S13G20
1 Membro
1 Guida realizzata
3Commenti sulla guida
I need to take my SX230 apart to replace the battery or capacitor responsible for storing the date and time when you remove the battery to charge it. anytime i remove the battery to charge it, my camera looses its date and time, do you know what i need to do to fix this issue?
Thank you! Just replaced the screen on my SX220 - very similar, a couple of screws in different places, but nothing I couldn't figure out. Did take a good bit longer than 4-5 minutes though - that's perhaps for someone who's done a few before! Thank you again.
Suggest additional illustrations for “pull off camera front casing” and steps 6,7, and 8 to show removal of screen, replacement, and reassembly.
