Introduzione

How to remove the outer casing of your Canon PowerShot SD870 IS.

Parti

Nessuna parte richiesta.

  1. Remove the wrist strap, if present.
    • Remove the wrist strap, if present.

    • Remove the lithium-ion battery.

    Aggiungi Commento

  2. Remove the two 4 mm Phillips #00 screws on the bottom of the camera.
    • Remove the two 4 mm Phillips #00 screws on the bottom of the camera.

    • Remove the screw next to the wrist strap attachment.

    • Pull up the “A/V OUT DIGITAL” cover and remove the screw above the USB port.

    Note: The PH000 bit from my iFixit toolkit fits the screws better than the PH00 described above. The 00 bit is too pointed to bottom out in the screw and therefore does not engage as well.

    wayne - Replica

    • Carefully unhook the “A/V OUT DIGITAL” cover from the hinge.

    With the camera I was repairing, to remove the front cover as shown below, it was necessary to first remove the two smaller screws on the opposite end of the body from the “A/V OUT DIGITAL” cover. That is . . . the screws shown in step 5 which in my camera also hold the front cover in place (design change apparently).

    RWM

    wayne - Replica

    • Pull the front cover from the camera by using gentle upward pressure.

    Aggiungi Commento

    • Remove the two Phillips #00 screws from the flat end of the camera.

    • Remove the black L-shaped side cover plate.

    • Remove the silver u-shaped retainer plate.

    Aggiungi Commento

    • Slide the back casing off.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Zach pelley

Membro da: 19/04/2010

58 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 10-45, Garner Spring 2010 Membro di Cal Poly, Team 10-45, Garner Spring 2010

CPSU-GARNER-S10S10G45

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 4

Tutti i Tempi: 7,815