Aggiusta la tua roba Comunità Store

Rilasciata nel novembre 2020, la consolle PS5 si caratterizza per la capacità grafica notevolmente migliorata e un innovativo controller DualSense. Lo schema cromatico futuristico in bianco e nero segna una grande svolta rispetto al design delle PlayStation del passato.

189 Domande Visualizza tutte

Opzioni

HDMI torn from board and damaged traces

I acquired a ps5 that had a claim of a bent hdmi port, but was definitely more than that. Hdmi port was broken off the board and the many of the pads and traces are damaged or missing. I was going to try and run new traces but I'm, 1 not sure if it's too far gone and 2 was wondering if the routing on the board is the same on both versions of the motherboard EDM-010 And EDM-033. here on ifixit you can see the EDM010 BUT NOT 033

Block Image

Block Image

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Sì No
Punteggio 0
2 Commenti

Not a slim, and having a he'll of a time removing all that solder

da

@rguilmette1977 hmm, it’s probably a new revision then. Yes.. this need to be removed first before you can proceed to the repair part. Hopefully you can repair this board!

da

Aggiungi un commento

2 Risposte

Filtra per:
Più utili Più recenti Più Vecchio
Risposta Più Utile

Opzioni

someone has been working on that before, you can tell with all that damage and the uv mask

Questa risposta è stata utile?

Sì No
Punteggio 1
Aggiungi un commento

Opzioni

Hi Rob!

Oh dear, this motherboard do have some serious damage there. It’s very difficult to repair this one. But the only thing left to do is to run new traces.

Is this the PS5 Slim version by any chance?

it’s easier to replace this motherboard as the HDMI port is completely ripped off the hard way…

Questa risposta è stata utile?

Sì No
Punteggio 1

2 Commenti:

Not sure what solder they used, but it's a nightmare trying to wick up. My wick keeps soldering to the board and the solder goes nowhere. I even cranked up the temp on my iron

da

Did you tried to put some fresh solder on your wick? Perhaps the old solder will come along in the copper wick as well. Also try some flux to get it off.

da

Aggiungi un commento

Aggiungi la tua risposta

Rob G sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 37

Tutti i Tempi: 37