My Whirlpool stacked washer dryer is slowly filling with cold water when off. It is only 1 month old. We are on city water so I can't imagine a buildup already (I mention this because of another post I read). I'm not even quite sure how to get it to drain so that it won't overflow.
Questa è una buona domanda?
Rep: 452,8k
11
367
1,4k
Hi,
What is the model number of the washer?
Usually there is a wire mesh filter in the water inlet hose connection where it screws into the machine or in some machines the filter is in the machine at the same connection point.
Check if there is a filter there or not and if it is there that it is not damaged. Even city water sometimes has grit in it (old pipes?) which could possibly lodge in the water inlet solenoid valve in the machine, preventing a good seal when it is closed.
If everything checks out then try filling the machine once or twice with cold water and see if this flushes any debris out of the valve and that it closes properly after that.
If it doesn’t then get the machine repaired under warranty as it might be a faulty cold water inlet solenoid valve.
In the meantime to prevent it from filling when it is switched off, simply turn off the cold water tap that supplies the machine and only turn it on for as long as needed when washing and then turn it off again, until the problem is fixed.
Questa risposta è stata utile?
Rep: 685,4k
3,4k
1,1k
2,6k
This is most commonly cause by low water pressure. Make sure the shut off valve to your water heater is fully open .
Questa risposta è stata utile?
Ultime 24 Ore: 1
Ultimi 7 Giorni: 1
Ultimi 30 Giorni: 5
Tutti i Tempi: 46
