Salta al contenuto principale

Introduzione

This guide is for the replacement of the control panel and microphones for the Sonos One.

  1. Disconnect all power cords. Remove the rubber foot and plastic screw guard on the bottom of the device using a plastic opening tool. Remove the rubber foot and plastic screw guard on the bottom of the device using a plastic opening tool.
    • Disconnect all power cords.

    • Remove the rubber foot and plastic screw guard on the bottom of the device using a plastic opening tool.

  2. Remove the four 10mm Torx T10 screws from the bottom of the speaker. Remove the four 10mm Torx T10 screws from the bottom of the speaker. Remove the four 10mm Torx T10 screws from the bottom of the speaker.
    • Remove the four 10mm Torx T10 screws from the bottom of the speaker.

  3. Remove the bottom cover by squeezing the protective cover slightly while pushing up with your fingers. Remove the bottom cover by squeezing the protective cover slightly while pushing up with your fingers.
    • Remove the bottom cover by squeezing the protective cover slightly while pushing up with your fingers.

  4. Batterie per PC portatili

    Una soluzione semplice per un grande aumento di potenza.

    Acquista ora

    Batterie per PC portatili

    Una soluzione semplice per un grande aumento di potenza.

    Acquista ora
  5. The protective cover clip is very thin and deforms easily. Remove the single 8mm Torx T10 screw and protective cover clip. Remove the single 8mm Torx T10 screw and protective cover clip.
    • The protective cover clip is very thin and deforms easily.

    • Remove the single 8mm Torx T10 screw and protective cover clip.

  6. Slide the protective cover upwards to remove. Slide the protective cover upwards to remove.
    • Slide the protective cover upwards to remove.

  7. Use the pointed end of a spudger to remove the covers that hide the screws. Remove the four 9mm Torx T8 screws from around the perimeter of the control panel. Remove the four 9mm Torx T8 screws from around the perimeter of the control panel.
    • Use the pointed end of a spudger to remove the covers that hide the screws.

    • Remove the four 9mm Torx T8 screws from around the perimeter of the control panel.

  8. With the front of the unit facing you, lift the control panel up using your thumbs. There's a ribbon cable attaching the control panel to the speaker so work slowly.
    • With the front of the unit facing you, lift the control panel up using your thumbs.

    • There's a ribbon cable attaching the control panel to the speaker so work slowly.

  9. Use a spudger to flip up the retaining flap on the control panel ribbon cable ZIF socket. Pull the control panel ribbon cable out of its socket. Pull the control panel ribbon cable out of its socket.
    • Use a spudger to flip up the retaining flap on the control panel ribbon cable ZIF socket.

    • Pull the control panel ribbon cable out of its socket.

  10. Pull the control panel away from the speaker to separate. Pull the control panel away from the speaker to separate.
    • Pull the control panel away from the speaker to separate.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Marcus Glowa

Membro da: 14/02/2018

674 Reputazione

5 Guide realizzate

Team

USF Tampa, Team S2-G1, Nance Spring 2018 Membro di USF Tampa, Team S2-G1, Nance Spring 2018

USFT-NANCE-S18S2G1

3 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 23

Ultimi 30 Giorni: 103

Tutti i Tempi: 1,274