Parti

Nessuna parte richiesta.

  1. Turn the system badge flap over (1) and then remove the ten M2x3 screws that secure the base cover to the computer (2).
    • Turn the system badge flap over (1) and then remove the ten M2x3 screws that secure the base cover to the computer (2).

      • Pry the edges of the base cover and lift it to remove it from the computer.

      • NOTE: Use a Torx #5 screwdriver for the base screws and a Philips screwdriver for the two M2x8 screws inside the badge flap.

    Aggiungi Commento

  2. Disconnect the battery cable from the system board [1].
    • Disconnect the battery cable from the system board [1].

    • Remove the seven M2x4 screws that secure the battery to the computer [2].

    • Lift the battery off the computer [3].

    • Do not apply pressure to the surface of the battery

    • Do not bend

    • Do not use tools of any kind to pry on or against the battery

    • If a battery cannot be removed within the constraints above, please contact Dell technical support

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Johnathan Hammond

Membro da: 28/02/2018

35.671 Reputazione

408 Guide realizzate

Team

Informative Technologies Inc. Membro di Informative Technologies Inc.

Community

15 Membri

925 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 4

Ultimi 7 Giorni: 29

Ultimi 30 Giorni: 114

Tutti i Tempi: 515