Flavio

This iPhone only sees near WiFi networks. The more far away the router the more poor signal I have replaced this antenna:...

This mac mini does not power on. Its dead. I have disconected every single cable to ensure that is no affecting it. So, I...

Hi. I have an INverter board from an Imac 27 mid 2010 EMC2390, the question is if I can replace the inverter on an iMac...

I have received an Imac of a client, that has a backlight dim in one sector of the screen as you can see in the picture. I...

It was ocurred to me with two iPhone 5s in the same day! I have replaced the screen taking care about the position of the...

Hi, I don't found anywhere how to replace the Screen of a moto Xt 550 Smart Mix, anybody? Thank you

Hi, I have an iMac that after made a test with ASD, it reports this error: Temp (TG0H) - GPU 0 Heatsync test 1 - Sensor...

I have an iMac 27 mid 2001 that does not wake up from sleep. The machine stays on, fans, hard disk ok. The screen stays...

I'm replacing an iPod nano 4th click wheel. The issue is when I connect the flex to logic board the iPod turns off. When...

I have a macbook pro that the screen is separated into 4 equal sections..all display the same image, and mouse...

Ia have similar imac (same year but 21 size) . The Led 1 lights on when connected. But when I push the power button ligh goes off. Any way when I measure with the multimeter pin 4 reads 12V. Any ideas?

The solution I found is to reconnect the display data cable and since a couple of days everything seems to be ok.

Does the iPad turn on by pressing de Sleep/Wake Button? If it does not, the problem is as jessabethany described

I´ve get the part from Luna Commerce (China). And I found a guy (I´m live in Argentina) that can repair iPhone logicboards. He could succesfully solder the sim card reader and the iPhone is alive again.

Bad Logic Board.

The guides available only show the procedure to open and remove the parts do not indicate how to put the new one, and not always reassembling the device is in reverse order. In this case, the touchscreen flex was the problem, it was folded up against the metal plate where the LCD is inserted, preventing this to be correctly seated. The cable must be placed so carefully folded so that it is right beside the front camera. The pictures are not good sorry. http://www.skymac.com.ar/IMG_0270.jpg

Bad LogicBoard

It was a damaged LogicBoard

The LogicBoard was damaged.

It was a damaged logicboard

I recommend the use of this device, it is really very good and saves time

sunshine S-918E LCD Screen separator

Could you provide some guide about home button 3G replacement? I can't find any help for this and the home button is a piece that regulary stops working on 3G's.