Good, what is under the Taptic, is it the microphone?

It is a curiosity that I would like to know, and it is that I can not find any photo taken from above, only from a side angle. Thank you

Metal i mean

One question, if I go through the aluminum mesh, with a pin to the bottom, do I hit the plastic or the speaker? it's a curiosity that is altering me a little haha. Thanks

Good night, one question, the speaker above, under that metal mesh, which is the speaker, or the edge of the speaker? I hope I understand. I mean, in case of bad luck, if I went through the mesh, would you give to the edge of the headset or the earpiece? And second question, is the headset mesh resistant? Both outside and inside? Thank you

Thanks for guide

A slightly strange question, do the L and R buttons rest on the plastic? If you were to press too hard, would the plastic hold that pressure? Or would the soldered pins break to the board? It is a doubt that is eating me. Thank you

Thanks Sam LionHeart, sorry for the delay, I thought no one was going to respond.

Photos

Photos 2

Photos [|3]

Hi, could you see a photo in high resolution, how is the earphone hooked? The frontal bone, I get curious about how it is maintained and how it is, and if it could sink without meaning to. Thank you

Hi, could you tell how the headset is hooked? From the top? Of how it 's inside hooked. Thanks greetings