Aiuto

Hydro plant with 2 nozzles, (a.k.a. "Schnödels" in German) generating 200w continuously with 17' head and about 1gal/sec volume. It has a brass turgo wheel, which looks like the fan in a jet engine. The generator itself is a permanent magnet setup, which are glued under the spinning hub, the pick up coils are embedded in the epoxy below. By raising and lowering the hub, I can optimize the resistance of the magnetic fields versus the available power from the water pressure...if that makes any sense to you. The fogged up box contains a heat coil, to which power gets diverted when the battery reaches overfull conditions, as determined by voltage regulator. The other image is my catchment, with a high tech refrigerator grill as an intake filter. Solar panels generate my power in the summer, and a little yamaha 3Kw genny is there as backup...hardly ever runs.

Block Image
Block Image
Block Image

Here is my shop for cedar kayak and furniture building, with attached greenhouse and solar panels in front.

Block Image

Since Mayer asked to see my solar set up, here are my panels:

Block Image

They are attached so I can tilt them as the sun moves across the sky:

Block Image

The battery bank and the Outback inverter and charge controller:

Block Image

Guide Completate

Le Mie Storie

Came out easy, awaiting to get chipset repaired

MacBook Pro 15" Core 2 Duo Models A1226 and A1260 Logic Board

Logic and keyboard replacement

MacBook Pro 15" Unibody 2.53 GHz Mid 2009 Logic Board

Domande

Risposte

  • Rispondi a: Mba boots to screen with vertical stripes
  • Rispondi a: Logic board which can boot via USB, but not via internal SATA
  • Rispondi a: MacBook Pro 17" 2009 doesn't power on even after keyboard replacement
  • Rispondi a: Is my MacBook Pro dead?
  • Rispondi a: Vertical lines issue on iMac late 2009
  • Rispondi a: Boots to grey screen with vertical bars
  • Rispondi a: Vertical lines issue on iMac late 2009
  • Rispondi a: Water Damage Repair: Clean as a whistle but won't boot?
  • Rispondi a: Error message: 4VDC/1/40000003VideoController fault
  • Rispondi a: Display issue, screen turning on for a while, then goes black.

Commenti Guida