Popped off flex cable connected to fan
I accidentally popped off the connector part of the flex cable, does anyone know how I can attach it back on?
Questa è una buona domanda?
Punteggio
1
750197
Rep: 13
1
1 Risposta
Risposta Più Utile
Rep: 782,8k
1,1k
893
2,3k
Tif properly only by soldering it back on. The solder pads look reasonable so it should be a straight forward solder job.
Questa risposta è stata utile?
Punteggio
4
Thank you for responding! I've never soldered before, would you know what kind of tools I should get?
It might be safer and cheaper to have a repair shop do it as they have the tools and know how. probably cost $25 from an old guy, $50 from a young tech.
@Tif if you have never done this, this may not be a good board to practice on. Anybody that has soldered before should be in a position to do this for you. Not sure where you are located but I would inquire in my local electronics store or hobby club. Colleges and RC clubs are also a great resource.
@oldturkey03 agree on all points. These ZIF type connectors have a tendency to go all melty if you're not careful. But a pretty straightforward job.
At the very least if you're going to have a go yourself, get some extra connectors just in case.
