Salta al contenuto principale

CECH-2101B only reads dual-layer Blu-Rays when held vertically?

Basically the problem is this: I can load most PS3 games into my CECH-2101B PS3 and they start up just fine. However BD movies and PS3 games that are dual-layer (aside from GTA5 for some reason) do not unless I physically lift the console and hold it vertically (with the disc drive pointing upwards).

Is this a laser issue and can I fix it by swapping the laser?

Risposto! Visualizza la risposta Anch'io ho questo problema

Questa è una buona domanda?

Punteggio 0
Aggiungi un commento

2 Risposte

Soluzione Prescelta

It just needed a new laser. Done and done.

Questa risposta è stata utile?

Punteggio 0
Aggiungi un commento
Risposta Più Utile

This is very similar to the problem that a lot of PS2s (Primarily Slims) had where they would only read certain discs unless the console was in a certain position. The fix for those was a new laser, so based on the symptoms you have provided, we can safely assume it’s the laser. One thing I would check though is to make sure it actually spins properly if it does, then I would try the laser. If it doesn’t, then there’s a problem with the drive and it would probably have to be replaced. Here is a guide on how to remove the drive from the console to replace the laser or the drive itself: Sostituzione lettore Blu-Ray PlayStation 3 Slim

Questa risposta è stata utile?

Punteggio 1

1 Commento:

It definitely spins correctly because I can feel it while I'm holding it up (I can even feel it reengaging after it gives up the first time). Plus, as I mentioned I can read single-layer Blu-Rays (meaning the BD laser itself is alive) and CDs/DVDs.

da

Aggiungi un commento

Aggiungi la tua risposta

SolidSonicTH sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 14

Tutti i Tempi: 423