Rep: 685,4k
3,4k
1,1k
2,6k
I got in the capacitor kits, opened up a couple of different iMac G5 power supplies only to find them packed with gray silicon rubber adhesive. No wonder these things overheated. The question is: is there some easier way of getting this crude out other than cutting, picking and pulling?
Questa è una buona domanda?
Rep: 785,4k
1,1k
895
2,3k
The only stuff that I know of is Acetone. Of course not sure how the electronic components and the PCB will hold out to that. 3M makes a product that the boaters down here use. It's a citrus based adhesive remover and they say it takes of the silicon adhesive used in boating. It's a sticky situation with the components but worth a try. Good Luck.
Questa risposta è stata utile?
+ It's called ":goo gone", I'll give it a try and let you know
Thank you for accepting my answer and I hope you get the goo gone quickly.
Rep: 78,2k
385
96
162
You could pick a small piece off and test alcohol and other safe solvents on it. You would be looking for a reaction that would allow you to peel the stuff off. Of course ideally it would dissolve. Good luck with it and plus for the question--never an easy answer.
Questa risposta è stata utile?
+ for that. Isn't it cruel to waste the alcohol.
Ultime 24 Ore: 0
Ultimi 7 Giorni: 1
Ultimi 30 Giorni: 4
Tutti i Tempi: 768
