Salta al contenuto principale

Repair and support for the third generation of the Flip portable speaker by JBL.

68 Domande Visualizza tutte

Little part fell off the JBL flip 3 motherboard labeled 1R5

I dropped my JBL flip 3 speaker the other day and I started to hear a rattle inside so I decided to take it apart and see what it was and it was a small box at the top Corner of the motherboard labeled 1R5 and i don't know how to put it back on

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Punteggio 2

2 Commenti:

Exact same problem has happened to me, does anyone have a solution

da

the same excact thing happened to me

da

Aggiungi un commento

3 Risposte

@mtz13 without actually seeing what is going on, it is difficult to answer. Consider posting some picture of your board with your question. Use this guide Aggiungere immagini ad una domanda for that. The 1R5 sounds like a fixed 1.5uH inductor. Again without seeing it, this is only an assumption. Those are usually soldered to the board and there is not other way reattach it.

Questa risposta è stata utile?

Punteggio 0
Aggiungi un commento

Something similar happened to me. The 1R5 piece didn't break down fully and now one contact is lose. I think the only way is to solder it down. https://imgur.com/a/2y4Xy

Questa risposta è stata utile?

Punteggio 0
Aggiungi un commento

I had the same problem and solved it by cutting a wine cork in size to press the 1R5 piece against the contact. Good luck

Questa risposta è stata utile?

Punteggio 0
Aggiungi un commento

Aggiungi la tua risposta

Joe sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 1,420