Salta al contenuto principale
Unisciti alla Community delle riparazioni - Crea un account

iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement

Cosa ti serve

    1. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement, Battery: passo 1, immagine 1 di 1
      • Use a coin to rotate the battery locking screw 90 degrees clockwise.

      Chiedi a FixBot

      Aggiungi Commento

    2. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: passo 2, immagine 1 di 1
      • Lift the battery out of the computer.

      Chiedi a FixBot

      Aggiungi Commento

    1. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement, Keyboard: passo 3, immagine 1 di 1
      • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

      • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

      • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

      Chiedi a FixBot

      Aggiungi Commento

    2. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: passo 4, immagine 1 di 1
      • If the computer has an AirPort card installed, follow the next three steps to remove it.

      • Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

      Chiedi a FixBot

      Aggiungi Commento

    3. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: passo 5, immagine 1 di 1
      • Grasp the clear plastic tab on the AirPort card and pull toward the display.

      Chiedi a FixBot

      Aggiungi Commento

    4. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: passo 6, immagine 1 di 1
      • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

      Chiedi a FixBot

      Aggiungi Commento

    5. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: passo 7, immagine 1 di 1
      • Remove the four silver Phillips screws that secure the RAM shield.

      Chiedi a FixBot

      Aggiungi Commento

    6. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: passo 8, immagine 1 di 1
      • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

      Chiedi a FixBot

      Aggiungi Commento

    7. iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement: passo 9, immagine 1 di 1
      • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

      • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

      Chiedi a FixBot

      Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Annulla: non ho completato questa guida.

Altre 12 persone hanno completato questa guida.

Documenti allegati

iRobot

Membro da: 09/24/09

1 Reputazione

636 guide realizzate

0Commenti sulla guida

Aggiungi Commento

Visualizza statistiche:

Ultime 24 ore: 4

Ultimi 7 giorni: 13

Ultimi 30 giorni: 70

Tutti i Tempi: 16,895