Salta al contenuto principale

Wii Balance Board Back Cover Replacement

Cosa ti serve

  1. Wii Balance Board Back Cover Replacement, Unscrewing the Foot Cover: passo 1, immagine 1 di 1
    • Flip device upside-down so the plastic white board is facing the ground.

    • Locate the four feet in the corners of the Balance Board.

    • Unscrew the three 12.7 mm Phillips screws from each foot cover.

  2. Wii Balance Board Back Cover Replacement, Removing the Foot Cover: passo 2, immagine 1 di 1
    • Remove the gray plastic ring from the actual foot by lifting it up.

  3. Wii Balance Board Back Cover Replacement, Removing the Foot: passo 3, immagine 1 di 1
    • Separate the loose foot from the device by lifting it up.

  4. Wii Balance Board Back Cover Replacement, Removing the Additional Feet: passo 4, immagine 1 di 1
    • Repeat steps two and three on the remaining four feet.

  5. Wii Balance Board Back Cover Replacement, Unscrewing the Back Cover: passo 5, immagine 1 di 1
    • Unscrew the ten 12.7 mm Phillips #1 screws.

  6. Wii Balance Board Back Cover Replacement, Removing the Back Cover: passo 6, immagine 1 di 1
    • Lift off the gray back cover.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Cory Olson

Membro da: 09/29/14

891 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 13-8, Forte Fall 2014 Membro di Cal Poly, Team 13-8, Forte Fall 2014

CPSU-FORTE-F14S13G8

5 Membri

15 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 17

Tutti i Tempi: 1,025