Aggiusta le tue cose Community Store
Unisciti alla Community delle riparazioni - Crea un account

VTech VM3254 Camera Stand Replacement

Introduzione

If the camera stand is cracked or it seems to be unbalanced, you may need to replace it with a new one. Below are the following steps to replace the camera stand in order for there to be balance and it to stand securely.

Cosa ti serve

  1. VTech VM3254 Camera Stand Replacement, Camera Stand: passo 1, immagine 1 di 3 VTech VM3254 Camera Stand Replacement, Camera Stand: passo 1, immagine 2 di 3 VTech VM3254 Camera Stand Replacement, Camera Stand: passo 1, immagine 3 di 3

    • Unscrew and remove the two 8 mm Phillips #0 screws from the bottom of the stand.

    • Use the Jimmy tool to open the stand.

    • You may need to use an opening pick to hold it open.

    • Remove the bottom of the stand.

    Traduci
    Chiedi a FixBot

    Aggiungi Commento

  3. VTech VM3254 Camera Stand Replacement: passo 2, immagine 1 di 1

    • Replace with a new stand.

    • Use the solder to solder where the cords fit into place.

    • Careful with the solder to not break the motherboard or any other parts.

    Traduci
    Chiedi a FixBot

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Annulla: non ho completato questa guida.

0Commenti sulla guida

Aggiungi Commento

Visualizza statistiche:

Ultime 24 ore: 0

Ultimi 7 giorni: 5

Ultimi 30 giorni: 27

Tutti i Tempi: 601