Introduzione

Replacing the lens mount requires removing any lens that is already attached then simply removing the casing of the lens mount.

Parti

Nessuna parte richiesta.

Hold lens and camera securely with two hands.
  • Hold lens and camera securely with two hands.

  • With the hand holding the camera, push down on the lens button. Twist the lens counterclockwise and pull out to release lens.

Aggiungi Commento

Using your screwdriver, remove the four (3.5 mm) Phillips screws on the front face of the lens mount.
  • Using your screwdriver, remove the four (3.5 mm) Phillips screws on the front face of the lens mount.

  • Make sure to keep track of these screws and not misplace them.

Aggiungi Commento

  • Remove the silver plate by gently pinching with your fingers.

Aggiungi Commento

  • Now the black plate should be exposed. You can remove this again by gently pinching with your fingers and lifting up.

Aggiungi Commento

  • Using the tweezers, grab the thin silver ring and lift up.

Aggiungi Commento

  • The camera mount should now be barren and look like this.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Emily Trujillo

Membro da: 08/04/2014

1.081 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 8-9, Regan Spring 2014 Membro di Cal Poly, Team 8-9, Regan Spring 2014

CPSU-REGAN-S14S8G9

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 10

Tutti i Tempi: 1,784