Introduzione

This will be the initial step for getting into your device for repair.

Before any repair work can be done, one must remove the device from the vehicle. To do so follow this link to see a vehicle general removal of a stereo system.

Parti

Nessuna parte richiesta.

Locate face-plate eject button.
  • Locate face-plate eject button.

Aggiungi Commento

Press the eject button.
  • Press the eject button.

  • Remove the face-plate.

Aggiungi Commento

  • Remove two 4.9mm Phillips #00screws on the front of the device.

  • Remove two 7.5mm Phillips #00screws on the front of the device.

  • When the screws are removed, the eject lever may fall into the device. Make sure the device is held horizontal and level.

The screws in red do not seem to need to be removed unless you are trying to replace the eject lever. If you're not trying to replace the lever, it adds an unnecessary complication to putting it back together.

Dale Pearson - Replica

  • Rotate device 90 degrees to either side.

  • Use the plastic opening tool to pry open the top and bottom tab respectively.

  • Repeat on opposite side.

Aggiungi Commento

  • Remove front panel.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Team

USF Tampa, Team 10-2, Brown Fall 2014 Membro di USF Tampa, Team 10-2, Brown Fall 2014

USFT-BROWN-F14S10G2

3 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 6

Ultimi 30 Giorni: 22

Tutti i Tempi: 1,460