Introduzione

This guide shows all the steps leading up to, and including, the removal of the motherboard.

Parti

Nessuna parte richiesta.

Apply pressure to the back cover and slide it forward towards the camera.
  • Apply pressure to the back cover and slide it forward towards the camera.

  • Lift the back cover off the phone.

Aggiungi Commento

Holding the phone firmly, use the notches to grip and lift up the battery.
  • Holding the phone firmly, use the notches to grip and lift up the battery.

Aggiungi Commento

  • Remove the four 4.45mm screws at the corners of the phone.

Aggiungi Commento

  • Use the plastic opening tool to unhinge the locks around the edges of the phone.

  • Do not worry about the inner components of the phone; they are not connected to this case.

Aggiungi Commento

  • Lift the casing off of the phone.

Aggiungi Commento

  • With the screws removed, locate the antenna.

Aggiungi Commento

  • Using a Phillips head screwdriver, remove the 4.50mm screw holding the antenna in place.

Aggiungi Commento

  • Using the plastic opener tool, squeeze gently on the antenna cable connector and lift to remove the connector from its position.

Aggiungi Commento

  • Gently lift up on the antenna and remove it from the back of the device.

Aggiungi Commento

  • Remove the two 3.50mm screws connecting the motherboard to the case.

Aggiungi Commento

  • Use the plastic opener tool to detach the three ribbons on the motherboard.

Aggiungi Commento

  • Lift out the top right ribbon from its slot on the motherboard.

Aggiungi Commento

  • Use the plastic opener tool to unhinge the the locks on the side of the motherboard connecting it to the front casing.

Aggiungi Commento

  • Lift the motherboard away from the front casing.

Aggiungi Commento

  • After removing lifting up on the motherboard, the front casing and center frame should be separated as shown.

Aggiungi Commento

  • Using the plastic opener tool, gently pry away the side strip control buttons from the metal center frame.

  • There are three strips total: one on the right, left, and top of the phone.

Aggiungi Commento

  • Using the plastic opener tool, pry the speaker connector away from the back of the motherboard.

Aggiungi Commento

  • Using the plastic opener tool, remove the speaker from its setting.

  • Pry where the wire enters the speaker.

  • The speaker has adhesive on the bottom, thus removing it will require a bit of wiggling.

Aggiungi Commento

  • Gently lift the motherboard from the center frame.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Brayton

Membro da: 12/10/2011

40 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 3-13, Regan Fall 2011 Membro di Cal Poly, Team 3-13, Regan Fall 2011

CPSU-REGAN-F11S3G13

4 Membri

16 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 11

Tutti i Tempi: 4,750