Salta al contenuto principale

Introduzione

A guide showing how to replace the display unit for the Samsung A3 2015 model

  1. Heat up the edges of the display with a heat gun or iPad opener.
    • Heat up the edges of the display with a heat gun or iPad opener.

  2. Using a pick or slim plastic tool, work around the edge of the frame to loosen the glass. Watch out for the ear speaker, camera and light sensor on the top of the phone.
    • Using a pick or slim plastic tool, work around the edge of the frame to loosen the glass.

    • Watch out for the ear speaker, camera and light sensor on the top of the phone.

    • When working the glass free around the bottom of the phone, slide the tool out to avoid damaging the left and right home buttons (as shown in picture 2).

    • NOTE: The LCD is also glued to the frame and will most likely break when removing the display.

  3. Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now

    Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now
  4. Once the display has been disconnected, lift the top of the display away from the phone to expose the home buttons (Shown in green) Pry the contacts gently off the underside of the glass and push them back into the recesses on the phone (shown in yellow).
    • Once the display has been disconnected, lift the top of the display away from the phone to expose the home buttons (Shown in green)

    • Pry the contacts gently off the underside of the glass and push them back into the recesses on the phone (shown in yellow).

  5. Connect the new display and seat it in the phone, without removing the plastic for the adhesive.
    • Connect the new display and seat it in the phone, without removing the plastic for the adhesive.

    • Turn the phone on to make sure the display and home buttons work. If you glue the display without testing it first, it's a pain to take it off again once it has been glued and runs the risk of the display breaking.

    • If the display works, remove the plastic covering the adhesive and seat the display in the phone. Push gently around the edges to ensure a good seal

Conclusione

To reassemble your device, follow these instructions in reverse order. Do not attempt this while driving or lovemaking :)

Altre 34 persone hanno completato questa guida.

Harvey

Membro da: 15/02/2016

2.463 Reputazione

6 Guide realizzate

The lcd on my phone was physically glued to the inside of the phone so it broke when trying to remove it (which wasn't a problem as it was dead anyway) but this needs to be mentioned as it isn't!

Clems - Replica

nice man really cool staff

Shelton Chiuswa - Replica

Is the concept the same with newer models of the Samsung Galaxy A3?

Frederik Novak Jansen - Replica

The 2016 Model is different, so I would look for the model specific repair information:

Samsung A3 2016 Model - A310F Display / LCD Replacement

Samsung A3 2016 Model - A310F Display / LCD Replacement

This is a guide I wrote for the 2016 model...Hope it helps!

Harvey - Replica

Hi great instructions. I tried and failed. I was using a cheap China one and it seemed that a chip on the back was holding it up and the screen was pivoting on it. Was it the wrong size or do i need a gasket type sealent around. Anybody can advise me. Thank you

John

johnorjoy - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 14

Ultimi 7 Giorni: 56

Ultimi 30 Giorni: 330

Tutti i Tempi: 39,860