Salta al contenuto principale

Parti

Nessuna parte specificata.

  1. Turn the laptop so that the bottom is facing up.
    • Turn the laptop so that the bottom is facing up.

    • Locate the panel that has an M on it and two air vents.

  2. Take the screw driver and carefully unscrew the screw that is located above the M in order to remove the panel. Put this screw in a bag or easily identifiable place.
    • Take the screw driver and carefully unscrew the screw that is located above the M in order to remove the panel.

    • Put this screw in a bag or easily identifiable place.

    • Remove the panel.

  3. After removing the panel, you will see two memory modules. Locate the four spring clips that are holding the memory modules in place. Place your thumb on each of the two spring clips for each memory module and push outward until the memory module pops up.
    • After removing the panel, you will see two memory modules.

    • Locate the four spring clips that are holding the memory modules in place.

    • Place your thumb on each of the two spring clips for each memory module and push outward until the memory module pops up.

    • Gently raise the memory module and lift it out of its socket.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Christopher

Membro da: 27/04/2010

8 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 16-2, Maness Spring 2010 Membro di Cal Poly, Team 16-2, Maness Spring 2010

CPSU-MANESS-S10S16G2

4 Membri

9 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 7

Tutti i Tempi: 5,491