Salta al contenuto principale

Introduzione

Wheels not working properly? Follow this guide for steps on how to replace the wheel system on a RYDIS H68 Pro.

Ricambi

Nessuna parte specificata.

  1. Flip the vacuum over so that the wheels are facing you. Use a Phillips #1 screwdriver to remove the four 10mm screws that surround the battery cover.
    • Flip the vacuum over so that the wheels are facing you.

    • Use a Phillips #1 screwdriver to remove the four 10mm screws that surround the battery cover.

  2. Lift up the battery cover to reveal the battery.
    • Lift up the battery cover to reveal the battery.

    • Remove the battery.

  3. Remove the eight 10 mm Phillips #1 screws. Remove the eight 10 mm Phillips #1 screws. Remove the eight 10 mm Phillips #1 screws.
    • Remove the eight 10 mm Phillips #1 screws.

  4. Hold the front bumper and pull it off. It requires a lot of force to pull the bumper off. It requires a lot of force to pull the bumper off.
    • Hold the front bumper and pull it off.

    • It requires a lot of force to pull the bumper off.

  5. Pry off the back bumper by going around the entire top of the bumper with the metal spudger. Pry off the back bumper by going around the entire top of the bumper with the metal spudger. Pry off the back bumper by going around the entire top of the bumper with the metal spudger.
    • Pry off the back bumper by going around the entire top of the bumper with the metal spudger.

  6. Remove three 10mm Philips #1 screws that are securing the wheel assembly.
    • Remove three 10mm Philips #1 screws that are securing the wheel assembly.

  7. Remove the 10mm Phillips #1 screw securing the spring. Then undo the spring from the plastic hook to completely remove it from the wheel assembly.
    • Remove the 10mm Phillips #1 screw securing the spring.

    • Then undo the spring from the plastic hook to completely remove it from the wheel assembly.

  8. Lift up on the plastic piece to remove the entire wheel assembly. Lift up on the plastic piece to remove the entire wheel assembly. Lift up on the plastic piece to remove the entire wheel assembly.
    • Lift up on the plastic piece to remove the entire wheel assembly.

  9. Remove the plastic frame by pulling outward on the two spots where it is fastened. Remove the plastic frame by pulling outward on the two spots where it is fastened. Remove the plastic frame by pulling outward on the two spots where it is fastened.
    • Remove the plastic frame by pulling outward on the two spots where it is fastened.

  10. Remove the four 10mm Phillips #1 screws around the edges of the cover. Remove the four 10mm Phillips #1 screws around the edges of the cover.
    • Remove the four 10mm Phillips #1 screws around the edges of the cover.

  11. Lift up on the top cover to remove it. Removing the top cover reveals the gear system consisting of three gears. Removing the top cover reveals the gear system consisting of three gears.
    • Lift up on the top cover to remove it.

    • Removing the top cover reveals the gear system consisting of three gears.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Shawn O'Meara

Membro da: 27/02/2017

101 Reputazione

1 Guida realizzata

Team

USFT-Lacy-S17S005G2 Membro di USFT-Lacy-S17S005G2

Meetup

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 7

Tutti i Tempi: 304