Introduzione

Use this guide to remove the right function board from the front panel of the DVD player.

Parti

Nessuna parte richiesta.

  1. Eject the disk tray from the DVD player before removing power supply.
    • Eject the disk tray from the DVD player before removing power supply.

    Aggiungi Commento

  2. Evenly lift upward on the disk tray front cover (not slanted, as pictured). This will allow for easier dissasembly of the player.
    • Evenly lift upward on the disk tray front cover (not slanted, as pictured). This will allow for easier dissasembly of the player.

    Aggiungi Commento

    • Remove 3 screws running along back edge of case cover.

    • Remove 2 screws from each side of case cover.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Grab edges of cover, pull outward slightly, and pull straight up.

    Aggiungi Commento

    • Lift up the 5 tabs securing the front panel to the chassis. There are 3 on the bottom, and 2 on the inside edges of the panel. Panel should then lift off the player.

    Be careful not to disturb the electrical connectors on the circuit board.

    philcarpenter439 - Replica

    • Remove 4 screws as shown.

    Aggiungi Commento

    • Push in plastic retainer tab on board.

    • Grasp edges of board and pull out.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Kevin

Membro da: 26/04/2011

351 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 18-20, Garner Spring 2011 Membro di Cal Poly, Team 18-20, Garner Spring 2011

CPSU-GARNER-S11S18G20

4 Membri

11 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 1,879