Introduzione

Describes how to replace the screen of the Nokia 3300B.

Parti

Nessuna parte richiesta.

Flip the Nokia 3300B over with the back-side facing towards you. Gently press the button on the back of the battery cover to release the cover and slide up.
  • Flip the Nokia 3300B over with the back-side facing towards you.

  • Gently press the button on the back of the battery cover to release the cover and slide up.

Aggiungi Commento

Lift the battery out of the back of the phone. It is easiest to lift the battery out of the phone from the right-hand side, as seen in the picture.
  • Lift the battery out of the back of the phone.

  • It is easiest to lift the battery out of the phone from the right-hand side, as seen in the picture.

Aggiungi Commento

Gently push the blue tabs on the top of the phone out of their slots. With the phone facing up, pop the blue faceplate off by using your fingernail (or some tweezers) and working your way around the phone. Note: If the blue cover does not detach easily use your finger nails to try and split it open, as seen in the picture.
  • Gently push the blue tabs on the top of the phone out of their slots.

  • With the phone facing up, pop the blue faceplate off by using your fingernail (or some tweezers) and working your way around the phone.

  • Note: If the blue cover does not detach easily use your finger nails to try and split it open, as seen in the picture.

Aggiungi Commento

With the screen still facing you, remove the blue faceplate.
  • With the screen still facing you, remove the blue faceplate.

Aggiungi Commento

Grab the sides of the keypad and lift it up vertically. If you encounter resistance while removing the keypad, be sure to lift up evenly on both sides, so the button's pin don't snap.
  • Grab the sides of the keypad and lift it up vertically.

  • If you encounter resistance while removing the keypad, be sure to lift up evenly on both sides, so the button's pin don't snap.

Aggiungi Commento

Using the Torx T6 bit of a Phillips precision screwdriver, remove the six screws on the phone's inner protective case, as seen in the picture. NOTE:  Be sure to save these screws so the phone can be reassembled later. NOTE:  Be sure to save these screws so the phone can be reassembled later.
  • Using the Torx T6 bit of a Phillips precision screwdriver, remove the six screws on the phone's inner protective case, as seen in the picture.

  • NOTE: Be sure to save these screws so the phone can be reassembled later.

Aggiungi Commento

Holding the phone with the screen facing you, remove the top half of the phone from the circuit board. Holding the phone with the screen facing you, remove the top half of the phone from the circuit board.
  • Holding the phone with the screen facing you, remove the top half of the phone from the circuit board.

Aggiungi Commento

Hold the top half of the phone with the screen facing you. Using a pair of tweezers, release the tabs holding the two distinct cases together. The tabs are very fragile.  Be gentle when releasing the tabs.
  • Hold the top half of the phone with the screen facing you.

  • Using a pair of tweezers, release the tabs holding the two distinct cases together.

  • The tabs are very fragile. Be gentle when releasing the tabs.

Aggiungi Commento

Be sure to remove both casings so that the screen is facing down. This will ensure that the screen does not fall out of its case.
  • Be sure to remove both casings so that the screen is facing down. This will ensure that the screen does not fall out of its case.

  • NOTE: The screen's part identification sticker is on the top back side of the screen. The screen will need to be replaced with the same orientation.

Aggiungi Commento

Tilt the casing back and the screen should fall out smoothly.
  • Tilt the casing back and the screen should fall out smoothly.

  • Replace the old screen with the new screen.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Chris Colwell

Membro da: 13/04/2010

77 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 18-65, Johann Spring 2010 Membro di Cal Poly, Team 18-65, Johann Spring 2010

CPSU-JOHANN-S10S18G65

4 Membri

9 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 3

Tutti i Tempi: 2,887