Aggiusta la tua roba Comunità Store

Nikon D90 Rear Case Replacement

Cosa ti serve

  1. Nikon D90 Rear Case Replacement, Rear Case: passo 1, immagine 1 di 2 Nikon D90 Rear Case Replacement, Rear Case: passo 1, immagine 2 di 2

    • Slide the eyepiece up and off the viewfinder.

    Modifica

  2. Nikon D90 Rear Case Replacement: passo 2, immagine 1 di 1

    • Using a PH000 screwdriver, remove the two 4.8mm Phillips screws from the back of the viewfinder.

    • Some screws may be JIS. Be wary of this if your PH000 does not feel like it is properly gripping the screws.

    Modifica

  3. Nikon D90 Rear Case Replacement: passo 3, immagine 1 di 1

    • Remove the two 6.4mm Phillips screws on the right side of the camera, near the SD card slot.

    Modifica

  4. Nikon D90 Rear Case Replacement: passo 4, immagine 1 di 1

    • Remove the two 6.4mm Phillips screws on the left side of the camera, near the I/O ports.

    Modifica

  6. Nikon D90 Rear Case Replacement: passo 5, immagine 1 di 1

    • On the bottom of the camera,

    • remove the two 5.3mm Phillips screws

    • and the other two 6.3mm Phillips screws.

    Modifica

  7. Nikon D90 Rear Case Replacement: passo 6, immagine 1 di 3 Nikon D90 Rear Case Replacement: passo 6, immagine 2 di 3 Nikon D90 Rear Case Replacement: passo 6, immagine 3 di 3

    • Using a spudger, separate the bottom panel from the rear case just enough to clear the two clips on the rear casing in the next step.

    Modifica

  8. Nikon D90 Rear Case Replacement: passo 7, immagine 1 di 2 Nikon D90 Rear Case Replacement: passo 7, immagine 2 di 2

    • Lift the rear case off of the back of the camera.

    • Don't pull the casing completely off yet, as the ribbon cables are still connected.

    • Be mindful of the two clips, making sure to keep the bottom panel far enough away to clear them.

    Modifica

  9. Nikon D90 Rear Case Replacement: passo 8, immagine 1 di 1

    • Set the rear casing off to the side so you can access the ZIF connectors.

    • The orientation shown in the picture seems to be the best position for the casing to sit comfortably without stressing the ribbon cable connections.

    Modifica

  10. Nikon D90 Rear Case Replacement: passo 9, immagine 1 di 3 Nikon D90 Rear Case Replacement: passo 9, immagine 2 di 3 Nikon D90 Rear Case Replacement: passo 9, immagine 3 di 3

    • Use a spudger to lift the black tab on the ZIF connector.

    • Disconnect the ribbon cables from their respective ZIF connectors on the logic board.

    Modifica

  11. Nikon D90 Rear Case Replacement: passo 10, immagine 1 di 1

    • Separate the rear casing from the camera.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 8 persone hanno completato questa guida.

Autore

con 7 altri collaboratori

Ryan Lutz

Membro da: 09/27/11

3.008 Reputazione

3 Guide realizzate

Distintivi: 32

+29 altri distintivi

2 Commenti

good guidance,easy to follow,thanks

ramalingeswarao kaza - Replica

I want to replace my Nikon D90 DSLR bad LCD, this guide will save me from costly repairs.

ramalingeswarao kaza - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 19

Tutti i Tempi: 4,198