Introduzione

Keypad installation can be used to replace a worn keypad or a keypad that is misaligned.

Parti

Nessuna parte richiesta.

Place thumb on the rubber tab on the lower back of the phone.
  • Place thumb on the rubber tab on the lower back of the phone.

  • Push away from the phone to release back panel.

Aggiungi Commento

Lift the back panel of the phone to expose battery (not shown here).
  • Lift the back panel of the phone to expose battery (not shown here).

Aggiungi Commento

  • Pull the antenna up to reveal two of the six screws.

Aggiungi Commento

  • Unscrew all six screws on the back side of the phone using a T-6 bit.

Aggiungi Commento

  • Gently separate the front and back sides of the phone, as shown in the picture.

  • Be careful not to break or bend the ribbon cables.

Aggiungi Commento

  • Detach the first ribbon cable by unplugging it from the motherboard.

Aggiungi Commento

  • Detach the speaker ribbon cable from the motherboard.

Aggiungi Commento

  • Remove the motherboard from the front half of the phone by gently shaking it loose. It should come out with little to no trouble.

Aggiungi Commento

  • Push lightly from the front of the keypad to remove it.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Haley S

Membro da: 11/03/2013

1 Reputazione

4 Guide realizzate

Team

Clemson, Team 13-6, Benson Spring 2013 Membro di Clemson, Team 13-6, Benson Spring 2013

CLEM-BENSON-S13S13G6

3 Membri

10 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 88