GoPro Hero+ LCD Image Sensor Replacement

Ultimo aggiornamento il May 28, 2021

5 minuti

Moderato

Introduzione

The image sensor is located behind the lens and is attached to the motherboard. Be careful in removing wiring from the motherboard, they are thin and small contacts and must be handled with care.

Cosa ti serve

Strumenti

Mostra di più…

Passo 1 Back Panel

GoPro Hero+ LCD Image Sensor Replacement, Back Panel: passo 1, immagine 1 di 2

GoPro Hero+ LCD Image Sensor Replacement, Back Panel: passo 1, immagine 2 di 2

Be sure to power off the GoPro before you start disassembly.
Pop up and pull back on the clip to remove the screen cover and expose the back panel with the touchscreen.

Traduci

Passo 2

Use the metal spudger to pry around the perimeter of the panel.
Pry the panel upwards by inserting the metal spudger into the corner crease between the panel and camera shell.

Traduci

Passo 3

Pry around the panel to ensure it is not attached to the device.
Move the panel to the side so you can access the internal components.
The panel is still attached to the rest of the device with a ribbon cable, so be sure to not tear or damage the cable.

Traduci

Passo 4 Battery

GoPro Hero+ LCD Image Sensor Replacement, Battery: passo 4, immagine 1 di 1

Peel back the rear panel ribbon cable that is adhered to the battery until it is completely separated from the battery.
Be careful of metal contacts on strip; they can be sharp.

Traduci

Passo 5

Attrezzo utilizzato in questo passaggio:

Tweezers

$4.99

Using tweezers, peel off the copper tape on the right side of the battery.

Traduci

Passo 6

Place the plastic opening tool at one of the edges of the battery then pry until the battery is removed from the GoPro.

Traduci

Passo 7

Use a pair of tweezers to disconnect the battery connector from the motherboard.
Gently pull the battery off the motherboard. Pulling vertically off the motherboard will give a clean release.

Traduci

Passo 8 MicroSD/Micro USB Port Assembly

GoPro Hero+ LCD Image Sensor Replacement, MicroSD/Micro USB Port Assembly: passo 8, immagine 1 di 3

GoPro Hero+ LCD Image Sensor Replacement, MicroSD/Micro USB Port Assembly: passo 8, immagine 2 di 3

GoPro Hero+ LCD Image Sensor Replacement, MicroSD/Micro USB Port Assembly: passo 8, immagine 3 di 3

Remove the two 6 mm Phillips #00 screws.
Remove the single 4 mm Phillips #000 screws.

Traduci

Passo 9

Remove the image sensor from the camera.
You do not have to unplug the black box to remove the USB/SD chip.

Traduci

Passo 10

Attrezzo utilizzato in questo passaggio:

Tweezers

$4.99

Grab the edge of the ribbon cable with the tweezers and gently pull until the cable is disconnected from the motherboard.
Be careful when removing the ribbon cable. You must pull gently or you can rip the ribbon off of its contacts.

Traduci

Passo 11

Gently lift the microSD/Micro USB assembly up and out of the device.

Traduci

Passo 12 Image Sensor

GoPro Hero+ LCD Image Sensor Replacement, Image Sensor: passo 12, immagine 1 di 1

Use your fingers and gently pull out the sensor from the motherboard by slowly and gradually pulling up on the image sensor box.
Do not yank on the image sensor, it can rip out the wiring or damage the motherboard.

Traduci