Parti

Nessuna parte richiesta.

  1. Make sure that your vacuum is unplugged from a power source.
    • Make sure that your vacuum is unplugged from a power source.

    • Press the black button just below the handle and extend the pole fully.

    Aggiungi Commento

  2. Press the black separator switch to separate the top and bottom halves of the vacuum.
    • Press the black separator switch to separate the top and bottom halves of the vacuum.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.

    • Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.

      • Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

    Aggiungi Commento

    • Once the housing is open, locate the solid chrome plated piece at the front end of the extendable pole.

    Aggiungi Commento

    • On the side of the motor housing which does not hold the engine, find the center track which runs along the inside of the housing.

    • Re-insert the chrome plated piece into the center track.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 280