Introduzione
Is your radar's display not powering on or just hangs on a black screen? If this is the case, then the display could be at fault. Follow this guide to replace the display on your radar.
Cosa ti serve
-
-
-
Remove the three 1.2 mm Phillips #1 screws on the back of the device.
Chiedi a FixBot
-
-
-
-
-
-
Carefully pry the grey frame off the black plastic covering using the nylon spudger.
-
-
-
Detach the orange flap from the motherboard using a nylon spudger.
-
Carefully remove the motherboard from the grey plastic frame.
-
-
-
Detach the remaining two orange flaps from the circuit board that is attached onto the grey frame.
-
-
To reassemble your device, follow these instructions in reverse order.
Team
UMass Dartmouth, Team S2-G3, Peak Fall 2018 Membro di UMass Dartmouth, Team S2-G3, Peak Fall 2018
UMASSD-PEAK-F18S2G3
3 Membri
28 guide realizzate
